Start-up
Page EN-13
3. If underfloor heating is installed at the set-
up location, place the cooling appliance
on an insulation plate made from sol-
id material. Make sure that the ambient
temperatures match the climate category
of the appliance (see “Intended use“ on
page EN-4).
4. Check the position of the appliance with
a spirit level.
(6)
(6)
5. Level out any unevenness on the ground
using both of the front screw feet (6).
6. Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
7. Repeat the adjustment until the appliance
is upright and secure. The appliance must
not wobble.
About climate categories
• Always ensure the prescribed ambient temperature is maintained (see “Intended use“ on
page EN-4).
Climate category means that the appliance is intended for operation at the specified ambient
temperature.
Zone designation
Code Definition
extended temperate zone SN
This cooling appliance is designed for use at ambient
temperatures of +10 °C to +32 °C.
temperate zone
N
This cooling appliance is designed for use at ambient
temperatures of +16 °C to +32 °C.
subtropical zone
ST
This cooling appliance is designed for use at ambient
temperatures of +16 °C to +38 °C.
tropical zone
T
This cooling appliance is designed for use at ambient
temperatures of +16 °C to +43 °C.
If the room temperature drops significantly below this, the appliance will not switch on as often.
This indicates that an unwelcome increase in temperature may occur.
