Start-up
Page EN-15
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure adequate air circulation,
– the entire space above the appliance
must be clear.
– the appliance should not stand directly
against the wall. Keep the appliance at
least 3 cm away from the rear wall.
3. Level out any unevenness on the ground
using the levelling foot (7) at the front. To
do this
– Close the door.
– Tilt the appliance backwards slightly.
– Turn the levelling foot inwards or out-
wards until the appliance is level.
– Reposition the appliance upright.
4. Check the position with a spirit level.
The appliance should not move when open-
ing the door.
Changing the door hinges
You can change the side on which the door
opens. The stop is on the right on delivery.
As this alteration requires some manual skills,
please read through the work instructions be-
fore altering.
In addition to the package contents, you will
require:
– Medium-sized cross-headed screwdriver
– Medium flat-headed screwdriver
– 8-sized spanner
Proceed as follows:
1. Ensure that the appliance is not connect-
ed to the power supply.
2. Remove the cover for the upper hinge
plate with a flat-headed screwdriver.
3. Remove the cover on the opposite side.
