HKS 8555A1
Getting started
15
Operation
Getting started
Connecting the refrigerator
NOTICE
Risk of damage!
If the refrigerator has been carried on its side for an
extended time, lubricant from the compressor may
have got into the refrigeration circuit.
• In this case, leave the refrigerator in its normal po-
sition for about 12 hours before switching it on. This
allows the lubricant enough time to flow back into
the compressor.
1. Clean every part of the refrigerator before turning it on for the first
time. (See chapter ‘Cleaning and maintenance’, page 19.)
2. Dry the refrigerator thoroughly afterwards.
3. Insert the shelves
4
,
5
and
8
at the desired heights.
4. Connect the mains plug to a properly installed socket (220 V
to 240 V, 50 Hz, 10 A).
5. Open the door.
6. Turn the temperature controller
1
to ‘7’. The lighting will turn
on, the compressor will start running after a short while, the re-
frigerant will start flowing through the piping, and you will hear
a slight noise.
Summary of Contents for HKS 8555A1
Page 52: ......