Connecting the appliance to
electricity
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance if
–
it shows visible signs of damage,
e.g. the power cord is defective,
–
it starts smoking or there is a smell
of burning,
–
it makes unfamiliar noises.
In such cases, pull out the mains plug
or unscrew/isolate the fuse and con-
tact our service department (see page
GB-25).
■
Connection to a timer or separate re-
mote control system for the purpos-
es of remotely monitoring and con-
trolling it is not permitted.
■
If the mains plug is no longer acces-
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
■
Do not kink or pinch the mains cord
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re and property damage.
■
Only connect the appliance to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the cooling unit has been transported
vertically, lubricant from the compres-
sor may get into the cooling circuit.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily acces-
sible and properly installed socket (220-
240 V~ / 50 Hz).
You will find all important information
about operation from page GB-10.
Start-up
Page GB-19
Summary of Contents for HKS 8555A3W
Page 30: ......
