The door hinges are on the right upon delivery.
As changing the door hinges requires some
manual skills, please read through the steps
of the procedure beforehand. To change the
door hinges, you will need the following tools:
– Cross-headed screwdriver
– 8mm or 10mm open-end spanner or sock-
et wrench
1. Pull out the blind plug from the top of the
door.
2. Loosen both screw covers on top of the
cover using a flat-head screwdriver.
3. Unscrew both screws on the left and
right-hand sides on top of the cover. To do
this, use a cross-headed screwdriver.
4. Slightly lever the cover out on both sides
at the front and lift the cover up. In doing
so, ensure you do not damage the tem-
perature controller.
5. Unscrew the three fixing screws for the
hinge plate and the two screws on the op-
posite side. To do this, use an 8mm span-
ner or a cross-headed screwdriver.
Remove the hinge plate.
6. Screw the hinge plate as well as the two
screws back onto the respective opposite
side.
Changing the door hinges
Changing the door hinges
Page GB-20
Summary of Contents for HKS 8555A3W
Page 30: ......
