– If you would like to reduce these distances,
you can fit an insulation plate between the
appliances.
– If underfloor heating is installed at the set-
up location, place the appliance on an insu-
lation plate made from solid material.
Setting up and aligning the
appliance
NOTICE
Risk of damage!
Insuffi cient air circulation may lead to
overheating and cause damage to the
appliance.
■
The entire space above the appliance
must remain clear.
■
The appliance should not stand di-
rectly against the wall (leave a mini-
mum clearance of 5 cm).
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
(5)
3. Level out any unevenness on the ground
using both of the front screw feet.
– Close the doors.
– Tilt the appliance slightly back and screw
in/unscrew the screw feet (5).
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
4. Tip the appliance backwards and bring it
into a horizontal position.
(13)
(14)
5. Screw the enclosed support leg (13) to
the bottom edge of the appliance door us-
ing the enclosed screw (14).
Start-up
Page GB-23