(5)
3. Level out any unevenness on the ground
using the two front screw feet (5).
– Close the doors.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet (5).
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
Basic cleaning
In order to remove the odour which is present
in all new appliances, wipe the interior with
diluted vinegar prior to first use. Then wipe it
out with clean water and dry all of the parts
off afterwards.
Commissioning the appliance
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re and property damage.
■
Only connect the appliance to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the appliance has been transported
horizontally, lubricant from the com-
pressor may make its way into the cool-
ing circuit.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily acces-
sible and properly installed socket (220-
240 V~ / 50 Hz).
The fridge light is automatically switched
on and off when the upper door is open or
closed.
You will find all important information
about operation from page GB-12.
Start-up
Page GB-25
