(20)
(3)
(19)
(4)
3. Position the door handle (4) on the side of
the appliance door (3); screw it tight with
the two screws (19) and attach the blind
plugs (20).
Cleaning before use
In order to remove the odour which is present
in all new appliances, wipe the interior with
diluted vinegar prior to first use. Then wipe it
out with clean water and dry all of the parts
off afterwards.
Connecting the appliance to
the mains
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance if it
–
shows visible signs of damage, e.g.
the power cord is defective,
–
starts smoking or there is a smell of
burning,
–
makes unfamiliar noises.
In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our Service de-
partment (see page EN-29).
■
Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■
Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cate-
gory III must be connected within the
house installation with at least 3 mm
contact clearance; consult a qualifi ed
professional if necessary (see “Ser-
vice” on page EN-29).
■
When positioning the appliance, en-
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■
Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
Getting started
Page EN-22
