Start-up
Page EN-15
Cleaning before use
In order to remove the odour which is pres-
ent in all new appliances, wipe the fridge and
freezer out prior to first use with a solution
made from 100 ml vinegar and 200 ml water.
Then wipe it out with clean water and dry all
of the parts off afterwards.
Electrical connections
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance, if it
–
it shows visible signs of damage,
e.g. the power cord is defective,
–
starts smoking or there is a smell of
burning,
–
makes unfamiliar noises.
In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our Service de-
partment (see page EN-34).
■
When positioning the appliance, en-
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges. This
can result in a break in the cable.
■
Do not locate multiple portable
socket-outlets or portable power sup-
plies at the rear of the appliance.
■
Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cat-
egory III must be connected within
the house installation with at least 3
mm contact clearance;consult a qual-
ifi ed professional if necessary (see
„Service“ on page EN-34).
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■
Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage to property!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■
If possible, do not tilt the cooling ap-
pliance horizontally.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
You will find all important information
about operation from page EN-18.
Summary of Contents for HSBS17590CWEI
Page 38: ......