Start-up
Page GB-34
– Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
Adjusting the doors
It may be that the doors are not on the same
level, even if the appliance itself is completely
level.
In this case, you can adjust the position of
the doors by lowering or lifting the door to the
fridge compartment.
The doors can be adjusted by a
maximum of 5mm.
1. Open the door to the fridge compartment
wide.
(44)
(45)
lower
lift
2. Turn the locknut (a) clockwise
with (44)two whole rotations to loosen it.
Use the spanner supplied to do this.
3. Turn the adjusting nut (45) in the desired
direction until the doors are on the same
level.
4. Tighten the locknut (45) again by turning it
anticlockwise.
Cleaning before use
To remove the odour that comes with all new
appliances, clean the appliance before using
it (see "Cleaning the fridge compartment“
and "Cleaning the freezer compartment“ on
page GB-26).
Mounting the water filter
Please take care when assembling and follow
the instructions below.
WARNING
Risk of electric shock!
Improperly mounting the water fi lter
to the wall can result in severe injury or
death.
■
Have the water fi lter mounted to the
wall by a professional.
■
Please ensure that the wall is suffi -
ciently load-bearing, and that there
are no cables or pipes in the drilling
areas. Before you drill, use a metal de-
tector to check the applicable areas.
Parts for wall mounting:
(41)
1x water filter
(46)
2 x wall bracket
(47)
2x screw, M4×25
(48)
2x dowel
Wall mounting
To mount the water filter (41) to the wall, you
will need the following tools (not included in
package contents):
– Drill
– Cross-headed screwdriver
– Folding rule
– Spirit level
– Pencil
The appliance may only be mounted
on a suitable, solid wall. For light-
weight walls, special dowels or anchors may
be required. Seek professional advice. It is
recommended to install it below a sink.
Summary of Contents for HSBS17990WEA1BK
Page 50: ......
