Start-up
Page EN-35
Aligning the appliance
1. Check the position with a spirit level.
(43)
2. Level out any unevenness on the ground
using the two front screw feet (43).
– Close the doors to do this.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
– Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
Adjusting the doors
It may be that the doors are not on the same
level, even if the appliance itself is completely
level.
In this case, you can adjust the position of
the doors by lowering or lifting the door to the
fridge.
The doors can be adjusted by a
maximum of 5 mm.
1. Open the door to the fridge wide.
(44)
(45)
lower
lift
2. Turn the locknut clockwise with (44)two
whole rotations to loosen it. Use the span-
ner supplied to do this.
3. Turn the adjusting nut (45) in the desired
direction until the doors are on the same
level.
4. Tighten the locknut (45) again by turning it
anticlockwise.
Cleaning before use
To remove the odour that comes with all new
appliances, clean the appliance before using
it (see "Cleaning the fridge“ and "Cleaning the
freezer“ on page EN-27).
Installing the water filter
Please take care when assembling and follow
the instructions below.
WARNING
Risk of electric shock!
Errors while mounting the water fi lter
on a wall may result in severe injury or
death.
■
Wall mounting of the water fi lter may
only be carried out by an expert.
■
Make sure that the wall is capable of
bearing the weight and that there are
no cables or pipes in the drilling are-
as. Before you drill, use a metal detec-
tor to check the applicable areas.
