Page EN-40
Troubleshooting table
Malfunction
Problem
Possible causes
Solutions, tips
Error code
E04
on the
display
Too much water in the appliance.
Pump out the water (see
page EN-19).
Switch the appliance off after the
water has been pumped out and
pull out the plug. Close the tap and
contact the service department (see
page EN-41).
The cycle duration dis-
played differs from the
actual duration of the
cycle.
This is not an error. The cycle dura-
tion is always adapted to the circum-
stances and re-calculated.
Error code
Error code
Possible causes
Solutions, tips
E01
Loading door is not closed properly.
Properly close the loading door (a “click” must
be heard).
E02
Problem with the water inlet:
Valve is closed.
Open valve.
Inlet hose is kinked.
Check inlet hose; dismantle if necessary and
re-align.
Inlet hose is clogged.
Clean filter on the inlet hose (see page EN-30).
Filter on inlet is clogged.
Clean filter on inlet (see page EN-30).
E03
The water does not drain away.
Check whether the drainage hose is clogged or
bent.
Check whether the lint trap is clogged (see
page EN-31).
E04
Too much water in the appliance.
Pump out the water (see page EN-19)
Switch the appliance off after the water has
been pumped out and pull out the plug. Close
the tap and contact the service department (see
page EN-41).
Summary of Contents for HWD75T214DE
Page 88: ......
