Seite EN-37
Start-up
Installing washing machine
– The installation site must be frost-proof.
– A water connection as well as a bath or
sink must be available.
– The mains plug must also be easily acces-
sible after the appliance has been set up.
– The ground must be secure, even, clean
and dry.
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat.
– Where there are rugs, carpet, parquet or
wooden floorboards, place a stable wood-
en plate measuring at least 60 × 60 cm un-
derneath the machine.
– If it is placed on a wooden plate or base,
the screw-on feet (15) should be fixed so
that the appliance does not dislodge itself
when spinning.
– Lay a smooth tiled floor or rubber mat un-
der the screw-on feet.
Aligning the washing machine
(15)
1. Loosen the lock nut of one of the screw-
on feet (15) underneath the appliance.
2. Using your hand, screw the foot in or out
as far as necessary. To adjust the foot,
– turn clockwise to screw out;
– turn anticlockwise to screw in.
3. Repeat this for the other screw-on feet
until the machine is standing completely
horizontally and securely.
4. Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine.
Connection diagram
~ 95 cm
~ 140 cm
95 cm
min.
60
cm
min.
100
cm
