Appliance parts / control element
Page GB-8
Risk of injury!
Improper handling of the appliance
may result in injury.
■
The appliance is heavy and bulky.
Seek the help of another person when
moving the appliance and changing
the door hinges.
■
Check that entry route and instal-
lation location are free of obstacles
(e.g. closed doors or objects lying on
the fl oor).
■
Wear protective gloves when moving/
installing the appliance and chang-
ing the door hinges.
■
Bases, doors, etc. must not be used as
steps or for support purposes.
■
Do not place any heavy objects on
the appliance.
■
Take care to prevent the risk of trip-
ping when laying the mains cord.
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Always abide by the prescribed am-
bient temperature (see product data
sheet at the end of this user manual).
NOTICE
Risk of damage
If the appliance has been transported
horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■
Do not tilt the appliance more than
45° or lay it on its side.
■
Allow the cooling unit to stand up-
right for 2 hours before start-up. The
lubricant will fl ow back into the com-
pressor during this time.
Improper handling of the appliance
can lead to property damage.
■
Do not use the door to pull or lift the
appliance.
■
The appliance must only be placed
on a level and fi rm surface. The sur-
face must be strong enough to sup-
port the appliance’s weight when ful-
ly laden.
■
Do not operate the appliance near
sinks, taps or containers fi lled with
liquids such as vases, aquariums, etc.
Make sure that the device does not
get wet.
■
The maximum load of 14 bottles per
bottle shelf must not be exceeded.
■
Do not use sharp or pointed objects
to unpack it.
■
Do not use any electrical parts inside
the appliance that do not conform to
the manufacturer’s recommended
design.
■
Do not use any mechanical devices or
means other than those recommend-
ed by the manufacturer.
■
When cleaning, please note:
–
Never use harsh, granular, soda,
acid, solvent-based or abrasive
cleaners. These attack the plastic
surfaces. All-purpose cleaners with
a neutral pH are recommended.
–
Door seals and plastic parts are
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
–
Do not clean the appliance parts in
the dishwasher.
–
Use only soft cloths for cleaning.
■
Wait 5 minutes after switching off.
Only then switch the appliance on
again.
■
Only use original accessories.
Summary of Contents for JC-201S
Page 52: ......
