Start-up
Page EN-20
Setting up and adjusting
the appliance (free standing
appliance)
NOTICE
Risk of damage
If the ventilation slits are covered, the
heat from inside the appliance cannot
be properly expelled.
■
Make sure that the ventilation slots
are not covered.
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
(2)
3. Level out any unevenness on the ground
using the four screw feet.
– Close the glass door (1).
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet (2).
– Tilt the appliance slightly forward and
screw in/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
glass door.
Integrating the appliance into
a kitchen unit
NOTICE
Risk of damage
If the ventilation slits are covered, the
heat from inside the appliance cannot
be properly expelled.
■
Make sure that the ventilation slots
are not covered.
The appliance can be integrated into a kitch-
en unit if necessary. The recess dimensions
can be found in the diagram on page EN-19.
1. First connect it to the power.
2. Slide the appliance into the recess. Make
sure that the mains cord does not be-
come trapped.
Basic cleaning
To remove the odour that comes with all new
appliances, clean the appliance before us-
ing it (see „Care and maintenance“ on page
EN-15).
