HanseLifter DSHT-05 Series Operating Manual Download

Page: 88 / 290

Page 7 of 16

DSHT-05 series

any kind of reproduction, even in parts, is not permitted.

can  lead  to  damage  to  the  equipment  and  endanger  the  operator  and  bystanders.  The  safety  valve  must
never  be  used  for  "weighing",  or  as  an  indicator  of  the  maximum  load.  Always  weigh  the  goods  before
loading them on to the lift table.

•

Always engage the safety bracket when the tabletop has been raised, to secure the tabletop against
unintentional lowering.

•

Disconnect power from the equipment before cleaning and maintenance.

•

Never use water to clean electrical components of the lift table. Use compressed air or a slightly damp cloth
to clean surfaces. Never touch live parts. Disconnect the equipment from the power supply before cleaning.

•

The lift table poses a certain amount of electrical danger. Injury to the operator and damage to equipment
and goods may occur if the lift table is used improperly, manipulated or not repaired correctly, or if incorrect
replacement parts are used.

•

Make sure that the equipment is never exposed to any moisture. If exposed to moisture, disconnect the
power supply from the equipment and dry it accordingly. Only use the device when it is completely dry.

•

The electrical components (motor, controller, etc.) can become warm during operation. Take care not to
touch any warm or hot parts. Wait until the parts have cooled down before the lift table is serviced, checked,
cleaned, etc.

Immediately discontinue work if components reach excessively high temperatures during operation, disconnect
the power supply and have the lift table checked by a qualified service technician before renewed use.

General safety instructions

Residual risks can occur when dealing with equipment, despite observance and compliance with all rules and
regulations.

Guidelines and instructions

Please note the following instructions in order to use the lift table correctly and as intended:

•

The operator of the lift table must be properly instructed in its use by their superiors.

In addition, applicable national legislation and regulations must be observed.

Operator

The operator must be mentally as well as physically capable of using the lift table.

Checks

A periodic inspection of the lift table must be carried out once a year in accordance with the statutory provisions,
and the test results must be recorded in writing.
The lift table must be examined by a qualified person. A test log must be created and entered in the test book.

Technical modifications

Any alteration or manipulation to the lift table and attached equipment is prohibited.
Should  you  have  any  questions  about  additional  accessories,  please  consult  the  dealer  from  which  you
purchased  the  additional  equipment,  and  consult  the  dealer  from  which  you  purchased  your  HanseLifter  lift
table.

HanseLifter is of course also at your disposal.

HanseLifter®
GESUTRA GmbH
Straubinger Str. 20
28219 Bremen
+49 (0)421 33 63 62 00
www.hanselifter.de

Original parts and accessories

Use  only  original  HanseLifter  parts  for  your  HanseLifter.  The  installation  of  spare  parts  and  accessories  from
other  manufacturers  is  not  tested  and  approved  and  can  adversely  affect  the  properties  of  the  equipment  for
this reason.  Any  liability of  the manufacturer is  excluded for damage caused  by  the  installation  of non-original
parts  and  accessories.  In  addition,  the  warranty  is  void  if  replacement  parts  or  third-party  accessories  are
installed without authorisation.