6.2 Stove Burner
The flame must not spread over the edge of the cookware, lace the cookware
centrally on the burner, so that it is stable on he support grid.
Ignition of the hob
Ignition must be done without any cookware or other object on the burners
●
To generate the flame, fully press down on the control knob and turn it anticlockwise to the fully open position.
●
Simultaneously push down the ignition piezo ignition button.
●
Once the flame has been generated press the knob down for a few seconds so that the flame remains lit.
If the burner does not turn on:
●
Turn the knob to the low flame position.
●
Proceed with manual ignition by using a match or gas lighter.
●
Check that there is gas in the cylinder.
If the device does not work, close the gas inlet tap and contact your dealer.
6.3 Visual inspection of the flame
●
LPG : Flame with blue internal pin point and clear outline.
6.4 Gas cylinders
The use of gas and or pressure different from those indicated by the manufacturer could cause irregular and incorrect operation of
the appliance. The manufacturer declines all liability for the incorrect or improper use of the appliance.
The gas cylinders to be used are the most common in the country where the appliance is used. The gas to be used is clearly
indicated on the back of the appliance. The gas to be used is clearly indicated on the label attached on the back of the appliance.
In any case, observe the following : Gas cylinders with the valve and pressure reducer must be placed in an upright position and in
the appropriate compartment, and access should not be impeded. Replacement of the cylinders must me performed without
impediment and with ease.
●
Close the taps of the appliance
●
Make sure no flames or fire are nearby.
●
Close the valve of the cylinder to be replaced.
●
Unscrew the pressure regulating valve of the empty cylinder,
take it out of the compartment .
●
Check for gas leaks with the use non non corrosive fluid.
●
Open the windows and immediately get all people out of the caravan.
●
Never touch electrical switches.
●
Never light matches or anything that could ignite gas.
●
Close the cylinder valve or gas tank and do not open until the leak is detected
●
Contact an authorised technician
