-
3
-
2. SAFETY INFORMATION
2.1 To avoid fatal accidents, please observe the following:
a. Ensure that you operate the equipment with the power source of correct voltage as provided
by your country;
b. Ensure that you comply with the laws of your country on position for welder’s installation,
high-pressure gas, storage of materials and treatment of exhaust;
c. Ensure that you wear the safety equipment and dress for the protection of your eyes and skin;
d. Ensure that there is proper ventilation in place of welding to prevent injury or harm from
smoke and gas exhaustion;
e. Do not open the DOS shell of the welder or use it in open position.
2.2 Prevention from burning and fire
a. Always keep the welder at least 50cm away from the wall and inflammables;
b. Keep sparks away from tinder or the open holes;
c. Fasten the welder properly with fixed bolts if it is to be installed on high position for use;
d. Do not weld tubes, hermetic tubes or vessels through which combustion gas is traveling.
2.3 Connection and usage
a. Always disconnect the power when trying to connect gas to the welder.
b. Do not touch any electrical components in the welder or wear wet or torn gloves.
c. Make sure the correct cables are being used.
d. Do not put weight on the cable or place the workpiece in contact with the cable.
e. Always make sure the cable is correctly connected and wrap any naked wires with
insulation tape.
f. Please only allow authorized electrician to earth the welder and other accessories.
g. Disconnect all power when not in use.
2.4 Other noticeable points
a. If the welder is put on inclined surface, please make sure it does not fall.
b. Do not use the welding power for tube defrosting.
