12
-
18
Hanskamp AgroTech BV (The Netherlands)
www.hanskamp.com
L
’
port
EN
Sluithek
-
Closing gate
-
Schließbügel
-
Porte arrière automatique
Maintenance
Check the L
’
port closing gate on a daily basis on faults and wear out. Do this by means
of a test on the output of de feed motors and through the manual switch on the cylin-
der (fig. 10.f). Make sure that the vibrations and noises caused by the L
’
port closing
gate are reduced as much as possible. For example by mounting grease nipple and
lubricate the moving parts.
Disassembly
In case of disassembly all parts should be separated on material type and should be
processed in the right type of waste management system.
Overview of changes included in these installation and operating instructions
Warranty Limitations
Costs and expenses resulting from the following are excluded from the warranty:
-
Using the equipment improperly, in violation of the specifications in the
installation and operating instructions;
-
The consequences of any intervention by mechanics other than mechanics
approved by Hanskamp for carrying out certain work;
-
Incidents such as freezing, ice, fire, flood, flooding or any other problems caused
by excessive water, and lightning;
-
Defective electrical system or earthing;
-
Damage to the electrical system caused by pests and the like;
-
Using compressed air improperly, in violation of the compressed air instructions
drawn up by Hanskamp in collaboration with suppliers, which causes a defect in
the pneumatic systems. These compressed air regulations can be consulted at
www.hanskamp.com.
The warranty does not apply to consequential damages unrelated to the machine itself.
All systems have been tested, However, in the event of defects, Hanskamp AgroTech BV
cannot be held responsible for consequential damage.
No.
Release date
Chapter(s)
Comments
1
05/2013
First draft
2.0
05/2014
All
Update to default, FAQ added
2.1
07/2014
Page 12
Warranty limitations compressed air requirements added
2.2
08/2014
All
New name and logo added
2.3
03/2015
All
New address
2.4
10/2015
All
General inspection
2.5
01/2017
Loose components
Figure 14
2.6
03/2018
ALL
Updated figures of new control PCB
2.7
01/223
Page 14
UKCA logo added
2.8
10/2023
Page 7 + 9
Page 7 image with UKCA logo inserted. Change from ±1005 to ±1100
mm, in text and image.
Important! Make sure that the person who operates the L
’
port closing gate, is
always standing on a safe place. When the L
’
port closing gate is in operation,
no persons should be near the L
’
port closing gate. It is not allowed to climb
the L
’
port closing gate when in use.
Please note! In case of maintenance make sure to always first switch
off the air pressure and the voltage to the feeding station.
Please note! When dismantling the L
’
port closing gate, always first switch off the
air pressure and voltage to the feeding station.
