9
-
18
Hanskamp AgroTech BV (The Netherlands)
www.hanskamp.com
L
’
port
EN
Sluithek
-
Closing gate
-
Schließbügel
-
Porte arrière automatique
Assembly:
1.
Check that all the parts are present using the item list. The list of
materials can be found in the appendix.
Please note! No fastening material is supplied to fit the L
’
port closing
gate to the out of parlour feeder.
2.
Measure from the heart of the feeding trough ±1100 mm and from the
heart of the anti
-
jump gate 575 mm high (fig. 3). Place at this measure
the standing leg tube (art. no. 4109) at the side fences. Fastening
materials are not included.
3.
Mount the tube assembly plate (art. no. 4106) and the two clamps
(art. no. 1058) to both standing leg tubes (fig. 3A). Mount them loosely
for further assembly but keep in mind to fasten them later!
4.
Place the 3
-
hole T
-
clamps (art. no. 4114) on top of the two standing leg
tubes
and connect the standing leg tubes with the cylinder assembly
tube (art. no. 4110) (fig. 3B).
5.
Mount the double 4
-
hole half scale with cylinder assembly eyes (art. no.
4103 & 4104) in the middle of the cylinder assembly tube (fig. 4).
Important! Make sure that the cylinder assembly tube is fixed well and
cannot rotate in the 3
-
hole T
-
clamp.
Make sure that the double 4
-
hole half scale cannot rotate on the
cylinder assembly tube and is mounted correctly in the middle. The
double 4
-
hole half scale should be in a position horizontal to the
cylinder assembly tube. The L
’
port closing gate will operate incorrectly
if these instructions are not followed.
6.
Slide the hinge tube (art. no. 4108) in the tube of the moving element
(art. no. 4111). Mount the hinge tube with the two tension pins (art. no.
1555) to both sides (fig. 5a).
7.
Loosen the screw 1559 in the leg tube (fig. 5B). Add trough the nipple
lubricant. This is for the prevention of noise and wearing out of the
moving parts.
8.
Mount the hinge tube to the standing leg tube. Attach the hinge tube
with the mounting clamps (fig. 3A). Make sure that the moving element
is in the middle
of the two
standing leg
tubes. Put the
moving element
on the available
anti
-
jump gate.
Important! Make sure the horizontal tubes of
the moving element are levelled when the
moving element is mounted and rests on the
anti
-
jump gate. Should this not be the case,
adjust the height of the standing leg tubes
again
.
3
± 1100 mm
3A
3B
4A
4
5A
5B
