13
-
23
Hanskamp AgroTech B.V. (the Netherlands)
www.hanskamp.nl/en
Dump
EN
Carrousel voersysteem—Carousel feeding system—Karussel
-
Fütterungssystem—Système d
’
alimentation carrousel
If the 4 kg drop tube is fitted with two PipeFeeder HighSpeeds, make sure that they do not
run for longer than a combined total of 10 seconds.
Important!
•
The Dump in only intended for cylindrical concentrate with a diameter
of Ø4 to Ø6 mm. The manufacturer cannot guarantee proper functio-
ning for other shapes or dimensions.
•
During the installation of the Dump ensure the pressure of the concen-
trate on the dosing unit is greater than 50 kg.
•
Never insert your hand into the bottom of the Dump when it is still in
operation or is connected to the electrical power supply (pic. 5). The
size of the exit point is limited by a bar to prevent cuts.
Maintenance
1.
Check the Dump installation daily for faults and wear. Do this by means of a control
test on the feed motors. Make sure that the vibrations and noise caused by the Dump
are reduced as much as possible.
2.
If the Dump needs maintenance and is connected to the controls ensure that the
Duump cannot start unexpectedly. Make sure there is no voltage on the installation!
To do this plug the power supply off at the control unit of the dosing motor.
3.
It is recommended to have repairs and maintenance carried out by a specialist.
4.
To avoid electric shocks or getting trapped in the feed auger never open the houssing
when the Dump is still running.
5.
For the safety of all concerned the user/owner of the Dump should follow the advice
and directions given in the installation instructions. If it is not possible to follow this it
is the responsibility of the user and the manufacturer cannot be held responsible/
liable for any injury or damage to or by the product.
Please note! In case of maintenance or disassembly make sure to always first
switch off the electricity of the installation.
Cleaning
Clean the Dump regularly with a moist cloth. Do not spray water under the hood in the
stock pipe. To guarantee the equipment functions correctly make sure the exit point is
clean an stays clean.
Please note! Do not spray with high pressure in or on the Dump. This can cause
blockage.
Disassembly
In case of disassembly all parts must be separated by material type for processing through
a suitable waste management system.
