DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3
15
Signal source
WaveGen:
Press this key to enter the setting interface of the signal source. Set
the waveform and parameters of the output signal from the signal
source.
Note: This function is only applicable to digital oscilloscopes with signal source chan-
nels.
Trigger control
Analog input channel switch. Press any button to open the corre-
sponding channel menu, and press again to close the channel.
Math:
Press the "Math" button to open the Math setup menu, and press
again to close the Math function.
Vertical offset:
Modify the vertical shift of the current channel waveform. Turn
clockwise to increase displacement, turn counterclockwise to de-
crease displacement. During the modification, the waveform will
move up and down, and the displacement information displayed
at the top right of the screen will change in real time.
Press this knob to quickly zero the vertical displacement.
Vertical voltage:
Modify the vertical scale of the current channel. Turn clockwise to
decrease gears and turn counterclockwise to increase gears.
During the modification, the waveform display amplitude will in-
crease or decrease, and the gear information at the bottom left of
the screen will change in real time.
Press this knob to quickly switch the vertical scale adjustment
mode to "Coarse" or "Fine".
