DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3
52
UART decoding explanation:
1. The decoded data is displayed in hexadecimal;
2. The decoded data shows purple;
3. When “?” Or “Please adjust the time base” appears, you need to adjust the time
base to get the decoding result.
LIN trigger [optional]
The LIN bus is a low-cost serial communication network defined for automotive distrib-
uted electronic systems. It is a supplement to other automotive multiplex networks such
as the controller area network (CAN). It is suitable for network bandwidth and perfor-
mance. Or applications where fault tolerance is not too demanding. The LIN bus is
based on the SCI (UART) data format and uses a single-master / multi-slave mode,
which is a special case in the UART.
The LIN signal message frame is displayed as follows:
Frame interval
Data 1
Data n
Checksum
Response
Frame interval
Frame
Interval
synchronization
Identifier
Response interval
Press the front panel Trig Menu button to open the trigger function menu.
[Type]
Select LIN and press V0 to confirm
[Data source]
Select CH1
～
CH4 or LA as the trigger source.
Note: LA must be inserted when LA is used as the trigger source.
