DSO-3004 USB
Series
Digital Oscilloscope
USER’S MANUAL 29
3.1 Setup the Oscilloscope
Using “AUTOSET” to display a signal automatically.
Auto setup functions one time each time you push the
“AUTOSET
” button. The function
obtains a stable waveform display for you. It automatically adjusts the vertical scale,
horizontal scale and trigger settings. Auto setup also displays several automatic
measurements in the graticule area, depending on the signal type.
Connect a signal to the CH1 input:
1. Connect a signal to the oscilloscope as described above.
2. Click the
“Acquire -> Autoset”
button.
The oscilloscope will change the current settings to display this signal.
Save Setup
The oscilloscope software saves the current setup before you close the oscilloscope
software. The oscilloscope recalls this setup the next time you run the software. You can
use the
“Save Setup”
menu to permanently save up to several different setups.
Load Setup
The oscilloscope can recall the last setup before the oscilloscope software was running,
any saved setups, or the factory setup. You can use the “
Load Setup
” menu to
permanently recall a setup.
Factory Setup
The oscilloscope software is set up for normal operation when it is shipped from the factory.
This is the factory setup.
To recall this setup, push the “
Factory Setup
” menu.
