Signal source
EN
Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 User manual
69
17.2
Set waveform modulation
Click
Modulation
to enter the modulation menu.
Modulation
There are two types of modulation, amplitude modulation (AM) and frequency
modulation (FM).
AM: Modify the amplitude of the original carrier signal according to the amplitude of the
modulated signal.
FM: Modify the frequency of the original carrier signal according to the frequency of the
modulated signal.
Shape:
Select the waveform of modulated wave, including sine wave, square wave and triangle
wave.
Frequency:
Set the frequency of the modulated wave, ranging from 1Hz to 50KHz.
Depth:
Sets the amplitude modulation depth. The settable range is 0-120%.
Offset:
Set the modulation offset of frequency modulation, that is, the offset between the
modulated waveform frequency and the original carrier frequency.The range is
0.1Hz~1KHZ carrier frequency. (Carrier wave is the modulated wave, and the carrier
frequency is the frequency of the selected waveform output by the signal generator
except noise and DC.) The sum of the modulation offset and carrier frequency must be
less than or equal to the sum of the upper limit of carrier frequency and 1KHz.
Set frequency, depth and offset:
Click on the numeric area to call out the numeric keypad to set the value.
17.3
Set burst
Click
Burst
to access the burst menu.
Click the the digital area of Count to call out the numeric keyboard to set the number of
pulses. The settable range is 1~2000000000.
When the burst menu is opened, the burst is on. When the burst menu is closed, thee
burst is off.
Click
Burst
to open the burst menu. Set
count
and click
Trigger
to get the
corresponding waveform state.
Summary of Contents for Tablet1000 Series
Page 1: ...Tablet1000 series Tablet oscilloscope User Manual 2022 05...
Page 12: ......
