Section 3: Programming
Operator Manual
1700w™
(Rev 1)
© Hantle 2010
3.15
To change a password, press the button for the appropriate password. You will be
prompted to enter the new password and then enter it a second time to verify. If
you forget your password please contact your dealer or distributor for service.
NOTE:
All passwords MUST be 6 digits. If you use a password that is less than 6
digits, the passwords may default back to factory if the machine is power cycled. If
your customer wants a 4 or 5 digit password, add zeros to the end to make it 6
digits.
WARNING:
The ATM will NOT go into service with the default master password.
You must change the master password from default! If you attempt to go in service
with the default master password, you will receive a
F0016
Error, which will notify
you that the master password has not been changed.
It is critical that you do not set the same password for each of the three levels. If
you duplicate the password, the lower level permissions will be the default.
For example, if the Operator Password is set to 123456 and you also set the Master
Password to 123456, then when you log in with that password, you’ll only have
access to Operator level commands. In this example, you’d have to change the
Operator Password to something else, and then 123456 would then allow you to log
in as Master. If you forget the passwords, you’ll need to reload the AP software to
reset.
