Section 3: Programming
Operator Manual
C
4000™
(Rev 1)
© Hantle 2010
3.7
CHANGE PASSWORD
This allows you to set each part of the “Secure Mode” Password. As with the other
passwords used in the
C
4000™, each must be a 6 digit number. If you change the
password and cannot remember it, you must clear RAM on the pin pad to reset.
NOTE:
In compliance with PCI specifications, you must change the Secure Mode
Passwords from default before any Master Keys can be entered. After changing the
Secure Mode Passwords, you must exit completely from the Operator Menu, and
reboot the machine. After this step, you can enter Master Keys
.
Entering Master Keys:
Use the chart below for entering Master Keys.
Please see Appendix C for specific Master Key instructions.
1 2 3
F
4 5 6
E
7 8 9
D
A 0 B
C
