installation & connection
12_
installation & connection
Removing a Micro SD Memory Card
Gently press down on the exposed end of the memory card as shown in the diagram to eject the memory
card from the slot.
J
`
Before removing the Micro SD card, in <
Setup (
)
>-<
Event
>-<
Storage
>, set the device to <
Off
> and press the [
Apply
]
button and turn the camera off.
`
If you turn off the camera or remove the Micro SD card that contains data from the product, the data may be lost or damaged.
POWERING AND NETWORKING
Connect the PoE device and camera’s PoE connectors.
J
`
Connect to a PoE (Power over Ethernet) enabled router’s PoE connector.
`
Use PoE (Power over Ethernet) that is compliant with the IEEE802.3af protocols.
Network Cable Specification
Item
Contents
Remark
Connector
RJ45
Ethernet
10/100BASE-T
10/100 Mbps
Cable
Category 5e
Max Distance
100M
DC Resistance ≤ 0.125 Ω/m
PoE Support
IEEE 802.3af
M
`
If you use a cable other than Category 5e standards, 100m of transmission distance is not guaranteed.
PoE Device
HDMI Supported
Monitor
Summary of Contents for QND-8012
Page 1: ...NETWORK CAMERA User Manual QND 8012 QND 8022...
Page 22: ......
