Scissor lift
Happ10
Version 4.0
©HAPP Australia Pty Ltd
Page 21
Chapter 6 Operation instruction
Lift operation by authorized personnel over 18 years only.
Apply the parking brake after positioning the vehicle on the lift.
Do not allow anyone to stay in lift area during raising and lowering cycles.
Closely watch the vehicle and the lift during raising and lowering cycles.
Observe the rated load capacity and load distribution.
Do not allow anyone to climb on lift or stay inside vehicle.
After raising the vehicle briefly, stop and check adapters for secure
contact. Make sure the vehicle doors are closed during raising and
lowering cycles.
In case of defects or malfunctions such as jerky lift movement or
deformation of the superstructure, support or lower the lift immediately.
Turn off the power. Contact qualified service personnel.
Figure: Example lift of vehicle, vehicles can be lifted from side or front of vehicle
so long as weight is balanced equally and the pads contact proper lifting points on
vehicle.
6.1 To raise the lift
l
Position the vehicle at the centre of the platform. Check to make sure
that the vehicle is secured.
l
Place the pads in the positions onto vehicle lift locations, lift location
must be a flat surface.
