28
29
ZERO DISPLAY STATE:
> the magenta button with the cleaning filter symbol remains on;
> the ambient temperature water icon comes on and is intermittent.
USER ACTIVITY:
> Press the ambient temperature water icon.
> A small quantity of sanitising water is discharged into the
container (twice, 20 seconds apart). Wait for the red water level
light to come on.
ATTENTION: wait for the ambient water icon to go out before removing
the tank, as water may still be coming out.
ZERO DISPLAY STATE:
> the magenta button with the cleaning filter symbol is on and
intermittent;
> the red water level light comes on;
> the red maintenance light with the wrench symbol lights up and is
intermittent.
USER ACTIVITY:
> Remove the container under the water dispenser, empty it and
store it.
> Press the magenta button with the cleaning filter symbol for 5
seconds.
> Ending the sanitisation procedure.
ZERO DISPLAY STATE:
> the red water level light is always on;
USER ACTIVITY:
> EXTERNAL TANK MODE:
Remove the external tank, fill it with tap
water and replace it on the ZERO;
> NETWORK MODE:
simply open the T-shut-off valve and the ZERO
automatically returns to network mode
.
OPEN
CLOSED
20
21
22
ZERO DISPLAY STATE:
> the cold water icon comes on;
> the ambient temperature water icon comes on.
CONGRATULATIONS, YOUR ZERO IS SANITISED, DESCALED AND YOUR FILTER IS
READY TO WORK!
VERY IMPORTANT NOTES.
1. REMEMBER TO ALWAYS FILL THE EXTERNAL TANK UP TO THE LEVEL.
Otherwise ZERO will run out of
water ahead of time. If it happens ZERO will resume from the previous phase
.
2. THE CONFIRMATION OF THE VARIOUS SEQUENCES RELATED TO THE ACTIVATION AND SHUTDOWN
OF THE WATER LEVEL LIGHT IS RELATED TO THE REMOVAL AND REPOSITIONING OF THE EXTERNAL
TANK, IF POORLY SUPPORTED, ZERO WILL NOT CONTINUE THE PROCEDURE.
In the event you encountered any difficulties, we report below all the FAQs typical for this procedure.
FAQ
1. What happens if the current jumps or if I mistakenly cut off the current? The ZERO sanitisation will
restart from the “25 minutes” phase (PHASE 8).
2. Can I stop the sanitisation once it has started? It is not possible to interrupt once the magenta
sanitisation button has been pressed because, even if ZERO is switched off, it is programmed to
reactivate from the “25 minutes” phase (pre-rinse phase) (PHASE 8).
5. If water comes out of the container for water drainage? It is important to follow the sanitisation/
descaling process step by step. If the 3L container overflows, it means that it has not been emptied
before giving the ok (icon activation) for the next action. At this point, empty the 3L container as fast as
possible.
23
Summary of Contents for ZERO
Page 20: ...38 39...
