32
33
MAINTENANCE
BOTTLES
SAFETY INFORMATION:
▶
WARNING:
DO NOT WASH THE HappyFrizz® CARBONATING BOTTLE IN THE DISHWASHER IF THE
“DISHWASHER WASHABLE” SYMBOL IS NOT PRESENT. IF, IN ERROR, THE CARBONATING BOTTLES ARE
WASHED IN THE DISHWASHER, DO NOT USE THEM AND INSTEAD THROW THEM AWAY THE USE OF
BOTTLES WASHED IN A DISHWASHER AFTER WHICH THEY ARE SCRATCHED, DARKENED, WORN OR
OTHERWISE DAMAGED CAN CAUSE SERIOUS INJURY TO PERSONS.
.
→
The expiry date is present on each HappyFrizz® carbonating bottle. Do NOT use out of date bottles.
→
Replacement HappyFrizz® carbonating bottles are available wherever you are able to purchase a
HappyFrizz® product.
→
To rinse the carbonating bottles, use cold or lukewarm but never very hot water. If necessary, for
cleaning of the carbonating bottles use a neutral dish detergent or the HappyFrizz® bottle sanitising
powder.
→
Do not use abrasive cleaning products or sharp tools to clean the ZERO system. If necessary, use neutral
dish detergent and wipe gently with a damp cloth.
→
Wipe up any water spills to keep the base dry.
→
DO NOT immerse in water or wash in the dishwasher. Otherwise, the ZERO system could be seriously
damaged.
→
Extraordinary interventions in any case require a good level of work experience. For any intervention of
this type contact the Biotech Trentino S.p.A. customer service.
LONG LIFE PACK
DISCOVER THE NEW KIT TO TAKE CARE OF YOUR
HAPPY FRIZZ PRODUCTS
INSTRUCTIONS FOR USE:
1. SANITISING POWDER FOR BOTTLES:
A: insert the powder contained in the sachet inside the
bottle full of water at room temperature.
B: Shake and leave the product to work for 20 minutes,
turning the bottle upside down to sanitise the gasket
and the cap.
C: Rinse the bottle thoroughly.
2. REPLACE OR REPOSITION THE GASKET
IN THE CYLINDER HOUSING
Including:
→
2 sanitising sachets
→
1 reserve gasket for the ZERO soda
maker and system.
External cleaning
Clean the outside with a damp cloth, do not use solvents or abrasive detergents.
See the instructions on p.12
Clean the tray and if necessary remove any residues.
Check the state and the integrity of the power supply cable.
Clean the external part with a damp cloth, do not use solvents or abrasive detergents.
After 1,500 L,/6 months/1 week of complete inactivity or if the quality of the incoming
water requires a filter change (little water comes out of the dispenser).
After 1.500 L,/6 months/1 week of complete inactivity.
Replacing the CO
2
cylinder
Cleaning the drip tray
Power cable
Checking the network connection
Replacing the filter
Sanitisation
Lost the gasket?
Fix it immediately with
a new one!
and
sanitise the bottles in
just a few steps
!
REPLACING THE CYLINDER
→
The
CO
2
HappyFrizz® cylinder is supplied. When the cylinder has run out, you can replace it with a full
one, at the sole cost of refilling at an authorised HappyFrizz® dealer.
→
For further information visit our website: www.happyfrizz.eu.
Summary of Contents for ZERO
Page 20: ...38 39...