12
13
USEFUL KEY:
PRESSURE
The term “key press” means the resting of a finger for more than 0.3 seconds on the desired icon. If the
time is less (for example during cleaning operations or drumming actions on the display by children, the
buttons do not activate, thereby avoiding accidental activations. This is also valid for exit from stand-by
(zone pressure active for at least 0.3s).
INSTALLATION OF THE CO
2
CYLINDER
1. HOW TO OPEN THE CYLINDER COMPARTMENT::
Open the cylinder compartment of the ZERO system, making it slide
outwards. Grip it using the lower raised part on the front.
2. HOW TO INSTALL THE CO
2
CYLINDER:
Remove the seal and the cap from the CO
2
cylinder. Insert the CO
2
cylinder in the dedicated compartment on the front of the ZERO
HappyFrizz® system and turn it clockwise by applying light pressure
until it is in position. To tighten, do so only manually: do not use
tools of any kind.
3: HOW TO CLOSE THE CYLINDER COMPARTMENT
Rest the lid on the compartment slide and push to the left following
the appropriate track.
SLITTA
FIRST ACTIVATION PROCEDURE :
IMPORTANT NOTES:
The first activation however takes place in tank mode. ZERO performs an automatic check-up to verify the
functioning of all the internal components present. If the filter is not mounted, the first activation cannot be
completed as the natural water bottle cannot be calibrated (emptying of the external tank during the first
70 s).
Your ZERO system has in any case been tested by our experienced staff before being packed. All the ZERO
systems undergo stress tests and functional checks, which is why it is normal to find a few drops of water in
the device (added to a sanitising substance). With the FIRST ACTIVATION procedure the sanitising residues
are expelled.
▶
WARNING:
During the first filling phase gurgling sounds can be heard due to the presence of air inside
the hydraulic circuit. These normally disappear at the end of the first activation
(“dead” times between the various phases allow the accumulation of air in areas where it is easily expelled
in the next phase)..
▶
WARNING:
This action is only required for the first installation.
▶
WARNING:
In the event of malfunctions, the maintenance light (wrench) comes on. In this case, contact
customer service: Fill the external tank with tap water; Position a suitable container to collect the water
that is dispensed.
> Fill the external tank with tap water.
> Position a suitable container to collect the water that is dispensed
(this step will activate your filter).
NOTE
: we also recommend using a support under the container to keep
it stable (see page 22).
The water supplied must not be ingested but, to avoid wasting it, you
can use it for your plants.
INSERT THE FILTER::
> Remove the protective film from the cartridge, keeping sharp tools
away from the red circled part;
> Dip the tip of the filter (area circled in red) in a glass of water to
improve the seal of the gaskets.
> Insert the filter in the appropriate slot of your Zero taking care to keep
the fins pointing upwards and in the position indicated by the black
arrow;
> Press the filter down and turn it clockwise.
> After a 90° rotation the filter is secured (rotation limit) as shown in the
figure. If the filter does not lock, reposition it as in the previous figure
and repeat the rotation operation.
WE START THE PROCEDURE
A
B
Summary of Contents for ZERO
Page 20: ...38 39...
