4
2. Check and Change Machine setting
Before start installing Borer device, please check setting of [Borer device] in machine setting. In case setting is [No], please
change it to [Yes]. In order to check and change this setting, you are required to enter into Maintenance Mode. Please refer to
Maintenance manual for entering Maintenance Mode.
2-1 Check Machine setting
1. When the machine is stopped, press MENU and Select
” NEEDLE” with
.
2. Press the SET.
3. Press MENU and move to submenu. Press right or down
key of
and check
(Set Borer) icon is on submenu.
4. If
is on submenu, Machine setting of [Borer device ] is
[Yes].(you can use borer device)
Please jump to step [ 3. Installation of Borer device ].
If
is not on submenu, Machine setting of [Borer device ]
is [No].(you can not use borer device)
Please follow step [ 2-2 Change Machine setting ].
5. To return to Menu display, please press ESC button at
above display.
If you press ESC button once more, return to running
mode.
2-2 Change Machine setting
+ Machine setting
Borer device: Yes (Use of Borer device YES)
+ Manual to be referred
[ Maintenance Manual for HCD series ]
9 Maintenance mode
9-1 How to enter maintenance mode
9-5 Setup- Machine setting
After finishing Check and Change Machine setting, please follow [3. Installation of Borer device].
