-D2 -125
13
-1
FRAME CONFIRMATION
20_1 M401
By default the machine checks if the pattern fits the embroidery area.
This helps you to check whether or not the selected pattern fits in the desired hoop.
This helps confirm positioningbetween the embroidery area and the pattern.
If you change the frame position by the frame move key, the display will be changed and you
can check the position onscreen.
The "monitor display" checks whether or not the pattern fits the embroidery area of the
frame you are going to use before starting the operation.
This is not a safety device that will prevent crashes if pattern size is too large for the frame;
it is intended for your reference only when judging the fit of a pattern to a given size frame.
After using "monitor display", do not move the frame. If you do so the machine may be
damaged due to the needle or pressure foot hitting the frame.
Make sure to perform "Registration number selection" when changing hoop size. If not
done, the machine may be damaged from the needle or pressure foot hitting the frame.
