Training Workbook: HAPPY HCS2-1201 Voyager Operation and Maintenance
Education Department
Chapter 1: Introduction and Basics
12
Embroidery Thread
General Thread Path
Thread should be properly, perfectly routed from cone to
needle or it will not feed properly and stop the machine.
Installation of upper thread on your machine
Layout of Cone/Needle Sequence
Needle numbers are arranged right to left, lowest number to highest.
needle 1
needle 2
needle 3
needle 4
needle 5
needle 6
needle 12
needle 11
needle 10
needle 9
needle 8
needle 7
Thread
must not be
allowed to
slack here
or catch.
Thread must
be docked
in the spring
here, not
hanging
loose.
Replacement cones
can be tied in here and pulled
through so the thread doesn’t have to be run manually
through the thread path. (See next page)