1
53
Error and measure
7-3-1
No. message Error measure page
030 Slow mismatch Inadequate adjustment of number of
(1)Make automatic speed setting. Initializing
low speed revolution.
(2)If not solved even after speed adjustment, (25-1)
Low speed revolution doesn't come replace CONT-J board ass'y.. (25-2)
below 100rpm.
050 C point Main shaft stops off its position.
Turn main shaft to plus direction to set to C point.
(24-4)
051 L sensor Poor lowest needle position sensor
(1)If photo sensor is stained, clean.
4-2-1
on timing detecting circuit board.
(2)Adjust timing. (25-1)
Damage in timing detecting circuit
(3)Replace main shaft timing circuit board. (25-2)
board, stained photo sensor, poor
(4) Initializing, Initializing of machine speed
adjustment of slit disc.
052 C sensor
Damage in color change point
sensor on timing circuit board.
Damage in timing detecting circuit
board, stained photo sensor, poor
adjustment of slit disc.
060 X limit
Drive frame went beyond limits in X direction.
(1)Move drive frame back to limits with move key.
061 Y limit
Drive frame went beyond limits in Y direction.
(2)Correct pattern size and setting contents.
090 Miss reception Error occurred when transmitting data. Let the machine read pattern data from first.
(5-4)(5-6)
091 No send Data is not put in for over 10 seconds. Let the machine read data from first. (5-4)(5-6)
103 Data format The machine can’t judge format of
(1)Check format of pattern data. (5-6)
pattern data.
(2)By setting reading of pattern data, (10-3)
set format properly.
104 Miss function
Timing to read pattern data doesn't Read pattern data again from the first.
(5-4)
conform. (5-6)
105 Dual function
One stitch data has more than 2
(1)Read pattern data again from the first.
(5-6)
functions. (2)
Check and modify the design data if there is wrong.
(10-3)
108 Improper read While reading pattern data, there Read pattern data again from the first.
(5-4)
accrued error in internal processing. (5-6)
110 Memory full While reading pattern data, memory Delete unnecessary patterns and read from
(5-5)(5-B)
exceeded its capacity. the outset. (23-1)
( ) ---Reference instruction book
Summary of Contents for HCH-701-30
