37
Check of height of pressure foot
3-2-10
1. Bring pressure foot down. (Either way mentioned below)
(1)press
P_FOOT key on control box.
(2)Turn gear with finger.
2. Bring needle bar down by finger.
Also you can move down the needle bar by maintenance
mode through menu of control box.
3. Turn upper shaft and set dial disc to [
0 degree
].
4. Insert [
Gauge I.2mm
] between needle plate and pressure
foot.
No gap between gauge and pressure foot or needle plate,
will be OK.
In case the space is not 1.2mm, loosen the fixing screw
and adjust height of pressure foot as following picture.
Summary of Contents for HCH-701-30
