-FC -4
2-1
ADJUSTMENT OF EMBROIDERY AREA
Please note that basically the upper arm and the lower arm should be parallel at locking posi
-
tion.
In case the thickness of the material is uneven, use adjusting set screw and eccentric pin to
change angle of the upper arm to give holding pressure evenly.
Lower arm
Set screw
Eccentric pin
Upper arm
Parallel
2-2
ADJUSTMENT OF UPPER ARM
Adjust width of the upper arm to meet size of tongue and embroidery design.
Width of the arm should have enough margins for embroidery area.
Loosen both side knob nuts for adjustment of arm.
Tighten all knob nuts after adjustment.
0 ~ 100mm
60mm
Knob nut
Knob nut
Arm
Arm
2_1 PA13
Open
Close
Open
Close
Right
Left
Lever
5mm ~
5mm ~
