-D2 -119
1
7
-1
QUEUE
19_1 M401
This sets up a succession of patterns that can be embroidered in any desired sequence.
The machine will proceed with the *various settings set to each pattern.
If you embroider a pattern like in Fig.1, you will need to set an offset as a pivot to each
pattern in advance. If the offset is set to the first pattern like in Fig. 2, you will need to set a
setoff point to the first pattern with the offset of the other pattern as a pivot. 14-8
If automatic original point return is set, the machine will return to the original point when
finished. If automatic original point return is not set, the embroider will finish at the end point
of the last pattern.
Setting example
Alter and Execution
This registers Queued patterns in order, and executes.
Needle bar selection and Pattern settings
Needle bar selection and Pattern Settings for patterns selected to QUEUE operation can be
applied by the following steps.
Registration of QUEUE setting
Up to 10 QUEUE settings can be registered.
Read QUEUE setting
Read registered QUEUE setting.
Pat.#03
Pat.#02
Pat.#14
Sidewise offset
of pat.#02
Sidewise offset
of pat.#14
Fig.1
❍
: Original point
●
: Start point of pattern
■
: Offset point
Lengthwise
offset of pat.#02
Lengthwise
offset of
pat.#14
Pat.#03
Pat.#02
Pat.#14
Sidewise offset of pat.#14
Sidewise
offset of
pat.#02
Sidewise offset of pat.#03
Lengthwise
offset of
pat.#02
Lengthwise
offset of
pat.#03
Lengthwise
offset of
pat.#14
Fig.2
■
❍
: Original point
●
: Start point of pattern
■
: Offset point
Summary of Contents for HCS3
