-SA -93
24-3
ERRORS AND WHAT TO DO
24_3 O512
y
130 Disk error
Unable to communicate continuously
with memory media or data disk.
Power down machine and after a 10
seconds, power on again.
If error remains, contact your Dealer.
131 Device no ready Memory media or data disk is not set.
Check if memory media or data disk is
properly set.
5-5
133 Bad disk
Improper or faulty memory media or
data disk.
Memory media that media reading unit
can't read or faulty media or un-initialized
media.
Data disk that disk drive unit can't read or
faulty data disk or un-initialized disk.
5-5
141 Not found name Designated pattern is not found.
Memory media is not correct.
5-5
142 Disk full
Memory media is full to capacity.
Clear unnecessary patterns or use a
different memory media.
143 Multi name
Another pattern with same name has
been detected while attempting to write
to memory media.
Change name, use a different memory
media, or overwrite existing pattern.
190 Cut blade
Thread cut knife is not at stop position. Follow the instructions below.
24-5
191 Cut Sensor
Thread cut knife is not at stop position.
Check if threads are jammed around
the thread cutting knife.
Press the thread cutting button 2~3 times.
If error remains, contact your Dealer.
23-2
23-4
193 Catcher
Thread catch hook is off its position.
Limit switch to detect position is not
"OFF".
Please follow the example below:
1. Check whether thread was actually cut
by thread cutting knife. If not, cut thread
and return catch hook to its normal
position.
2. If thread is actually cut, check if thread
catch hook on head has returned to its
position completely.
24-6
203 Install data
Error has occurred during update of
program.
Check an update program.
215 Frm. drive err
Frame movement did not complete
during normal movement. (Time over)
If this condition occurs frequently, contact
your Dealer.
217 Frm.drive data
Frame movement data loose.
255 Default Error
During embroidery, frame movement did
not complete until main shaft reach
"Lowest needle position".
Re-initialize machine speed setting.
Check adjustment of upper shaft timing.
(C point / L point)
If this condition occurs frequently, contact
your Dealer
25-2
.
o
N
y
a
l
p
si
D
r
o
rr
E
s
n
o
it
u
l
o
S
e
g
a
P
Summary of Contents for HCS3
