- 9 -
By pressing the “start” button once, the tanning time can be shortened.
The maximum tanning time will be indicated by the flashing numbers on the display.
The tanning time can be decreased or increased by using the “body cooling lower and higher” buttons.
By pressing the “start” button, the machine starts operating.
If during tanning the “stop” button is pressed once, the machine’s operation will be paused. The lights will go off and the ventilator will
continue for another three minutes. The tanning time continues to run down. The tanning session can be restarted at any time by pressing
the “start” button.
If the “stop” button is pressed a second time, the machine will start a compulsory after-cooling. The tanning session has now finished.
Operation without the use of an external timer or coinbox:
Body cooling lower Body cooling higher
Body cooling lower
Body cooling higher
Other control functions:
By pressing the “body cooling higher” button, the body cooling can be increased.
By pressing the “body cooling lower” button, the body cooling can be lowered.
Note: The body cooling function cannot be switched off because it is also used to discharge internal heat from the doors.
Summary of Contents for Luxura V7
