HAPRO PROLINE Owner'S Manual Download

Page: 6 / 76

Contact your authorised Hapro dealer imme-
diately if this unit does not function as out-
lined in this manual.

Do not operate this unit in humid spaces.

Always make sure the fuses can carry the load.
This unit has to be protected by ground fault
circuit interrupter (GFCI) of 0.03A.

Always disconnect the power to the unit at the
wall breaker (isolator) when servicing or clean-
ing the in-side construction of the cabine.
Maintenance for which the procedure is not
described in this manual should only be car-
ried out by a qualified electrician. Never clean
the electrical components with fluids.

Ensure that the canopy does not touch the
wall when opened.

Prevent the acrylic sheets from coming into
contact with sharp objects.

This unit may not be operated if:

•

the user is not wearing protective uv-

goggles;

•

an acrylic panel is missing;

•

one or more of the fans in the unit are not

functioning properly;

•

the timing mechanism is not functioning

properly;

•

the temperature inside the cabin is 30°C

or higher.

To ensure maximum tanning effectiveness,
change the acrylic sheet after every 1200
hours of operation.

9 To ensure maximum tanning effectiveness,

replace the lamps and the facial tanning lamps
according to manufacturer’s instructions.

10 Check local regulations to find out the proper

procedure for lamp disposal.

11 Note: only a special acrylic cleaner may be

used to clean the acrylic sheet. Never use
cleaners that contain alcohol, as these can
damage the acrylic sheet.

12 The UV-type of the tanning unit is indicated

on the specification sticker.

13 Ultraviolet radiation from the sun or UV appli-

ances  can  cause  skin  or  eye  damage.  These
biological  effects  depend  upon  the  quality
and  quantity  of  the  radiation  as  well  as  the
skin and eye sensitivity of the individual.

14 Excessive exposure may cause skin to burn.

Excessive repeated exposure to ultraviolet
radiation from the sun or UV appliances may
lead to premature ageing of the skin as well as
increase risk of skin tumours.

15 The unprotected eye may develop surface in-

flammation and in some cases, after a cataract
operation for example, damage may occur to
the retina after recessive exposure. Cataracts
may develop after prolonged exposures.

16 If the supply cord is damaged, it must be

replaced by the manufacturer or service agent
or a similarly qualified person in order to avoid
a hazard.

17 To replace lamps, remove by turning a quarter

turn to the left. Placement of new lamps is
done in the reverse to the above mentioned
procedure.

18 When installing the equipment, follow the

re-commended minimum distances listed in
the “Dimensions / Placement” chapter.

Read this first

The information contained in this manual regarding assembly and operation should be followed in full. Failure to do so may render the product warranty or liability on behalf of the supplier null and void. If there
is any uncertainty as to whether the instructions contained in this manual have been followed properly and entirely, you should contact the supplier of the sunbeds.

Note

Please consult enclosed tanning schedule for advised tanning times.

Repairs may only be carried out by qualified personnel.

Always disconnect the main power at the circuit breaker before
servicing or repairing the unit.