WARNING
7KHEDODQFLQJFOLSPXVWDOZD\VEH¿UPO\
pushed onto the blade till it touches the
edge of the blade. Failure to do so could
DOORZFOLSWRÀ\RIIDQGFDXVHSHUVRQDO
injury.
BLADE BALANCING INSTALLATION INSTRUCTIONS
17
1. Interchanging positions of adjacent blades (I)
can redistribute the weight and result in a
smoother operation. If wobble decreases,
leave blades (I) as they are. If wobble
increases, switch back to original position.
Attach the balancing clip in the balance kit (FF)
to the mid-point on the top edge of one blade
(I). (Fig. 1)
2.
5XQWKHIDQDWKLJKVSHHGDLUGRZQÀRZDQG
observe wobble. Repeat steps 1 and 2 for
each blade (I). Note which blade (I) has the
least wobble. On that blade (I), install the
balancing clip in the balance kit (FF) to the top
edge of the blade (I) near the blade holder arm
(H). (Fig. 2)
Start the fan and notice wobble. Stop the fan
and move the balancing clip in the balance kit
(FF) in small steps toward the end of the blade
(I). At each incremental step, turn on the fan
and observe the wobble. Determine the
location of the balancing clip in the balance kit
(FF) that gives the least amount of wobble.
3.
Peel the backing paper from one of the
weighted squares in the balance kit (FF).
Secure the weighted square in the balance kit
))¿UPO\WRWKHWRSRIWKHEODGH,FHQWHUHG
at the balancing clip in the balance kit (FF)
location and centered between the edges of
the blade (I). (Fig. 3)
Remove the balancing clip in the balance kit
(FF), start the fan and observe. If the wobble
still persists, repeat steps 1 through 3
until the wobble disappears.
GG
1
2
3
FF
A
A
H
I
I
A
I
FF
FF
