8
INITIAL INSTALLATION
4. Loosen all four preassembled mounting bracket
screws (R), then completely remove the two
mounting bracket screws (R) from the round holes
of canopy (E). Set aside for later use.
Detach mounting bracket (D) from canopy (E).
Note:
If using this item on an angled ceiling, snap
out the perforated section of the canopy cover (F).
5. Attach mounting bracket (D) to outlet box (not
included) using screws and washers provided with
the outlet box.
CAUTION:
It is very important to use the proper
hardware when installing the mounting bracket (D) as
this will support the fan.
Important:
If using the angle mount, ensure the
open end of the mounting bracket (D) is installed
facing the floor.
6. Remove the three fitter plate screws (I) and the
packing material from the motor assembly (G).
Discard the orange packing material from the top
and bottom of the motor assembly (G) but save the
three fitter plate screws (I) for later.
5
4
E
F
D
R
D
I
Perforated Tab
6
Standard and
Closemount
Mounting
Angle
Mounting
D
D
Packing
Material
Packing
Material
