13
1
Braided Cable
Outlet Box
Open Loop
SECONDARY HANGING SYSTEM
1. Feed the loop of the braided cable, preassembled on
the motor assembly (G), up through the outlet box
mounted in the ceiling.
2. Install secondary support screw (JJ), secondary spring
washer (MM) and support washer (KK) partly into the
side of the brace installed in the ceiling. Then loop
the braided cable up and over the ceiling brace and
place the open loop of the braided cable around the
secondary support screw (JJ).
Note:
The ceiling support brace may not be accessible
from below. If not, it must be accessed from above.
Important
: The braided cable must make a complete
circle around the support brace to secure the fan.
Hardware Used
JJ
Secondary Support
Screw
x 1
Support Washer
x 1
Secondary Spring
Washer
x 1
3. Tighten the secondary support screw (JJ), securing the
braided cable.
Hardware Used
JJ
Secondary Support
Screw
x 1
WARNING
: Secondary support is required for this
product. Failure to follow the steps below could result in
property damage and/or personal injury.
JJ
KK
MM
Brace
JJ
KK
A
MM
3
2
Note:
Closemount installations will not use downrod (A).
