16
FINAL INSTALLATION
3. Insert blade (K) through slot in the side of the motor
assembly (G). Align the holes of one blade (K) with
three blade screw holes in underside of the motor
assembly (G). Secure with three blade screws (BB)
and blade washers (CC). Repeat this step for the
remaining blades (K).
Hardware Used
BB
Blade Screw
x 9
CC
Blade Washer
x 9
4. Remove one of the three fitter plate screws (R)
preassembled to the fitter plate (H) and loosen the
other two but do not remove.
Connect the single-pin connector from the fitter plate
(H) to the single-pin connector from the light kit (I) --
blue to blue and white to white.
Align the slotted holes in the light kit (I) with the
loosened screws in the fitter plate (H). Turn light kit (I)
clockwise and replace the previously removed fitter
plate screw (R). Tighten all screws.
5. Install bulbs (L) into the sockets on the light kit (I).
Important:
Make sure you allow the bulbs (L) and
light kit (I) to cool before you replace the bulbs.
3
K
BB
CC
G
5
L
I
Slot
H
R
R
I
4
Single-pin
Connector
