9
ASSEMBLY INSTRUCTIONS
14. Remove one of the three light pan screws from the
light pan and loosen the other two but do not remove.
Connect the 9-pin connectors from the light pan to the
9-pin connectors from the light kit. Lift the two keyhole
slots in the light kit over the two loosened light pan
screws and turn in a clockwise direction. Then, use the
previously removed light pan screw to secure the light kit
to the light pan. Tighten all screws.
Light Kit
Light Pan Screw
Light Pan
9-pin
Connector
Glass Bowl
Light Kit
15. Attach the glass bowl to the light kit by twisting the
glass bowl tightly in a clockwise direction until it is secure.
CAUTION:
Avoid cross-threading the glass during
installation. Improper installation could cause the glass
bowl to be difficult to remove or fall, which could cause
serious injury.
13. Remove one of the four fitter plate screws
preassembled to the fitter plate and loosen the other three
but do not remove. Feed the 9-pin connector through
center hole in light pan. Align the keyhole slots in the light
pan with the loosened screws in the fitter plate. Turn light
pan clockwise and replace the previously removed fitter
plate screw. Tighten all screws.
Fitter Plate Screw
Keyhole
Slot
Keyhole
Slot
Fitter
Plate
Light Pan
13
14
15
Motor Screw
Blade Arm
12. Install the blade arm to the underside of the motor
assembly with previously removed motor screws. Tighten
each blade arm completely before moving to the next.
12
