10
DOWNROD-STYLE FAN MOUNTING
Install hanging ball of downrod (A) into opening of
mounting bracket (C). Align slot in hanging ball
with tab in mounting bracket (C).
DANGER:
Failure to align the slot in the ball
with the tab may result in serious injury or death.
Continue to
WIRING
on page 11.
6.
Slot
Tab
C
6
A
CLOSEMOUNT-STYLE FAN MOUNTING
Remove preassembled canopy cover from bottom
of canopy (B). To remove canopy cover from
canopy (B), twist canopy cover until the two small
protrusions on the inner lip of the canopy cover
align with the two notches on the bottom of the
canopy (B). Pull on canopy cover to remove.
NOTE:
The downrod (A), yoke cover (E) and
canopy cover are not used in this type of
installation.
1.
Canopy
Cover
Remove every other preassembled screw/
lock washer from top of motor housing (D).
2.
Screw/
Lock Washer
1
B
2
D
