10
FINAL INSTALLATION
1 .
Loosen all four mounting bracket screws (M), then
completely remove two mounting bracket screws (M)
from opposite sides of the mounting bracket (A) .
Slide the canopy (B) over the mounting bracket (A),
aligning the slotted holes in the canopy (B) with the
pre-loosened mounting bracket screws (M) in the
mounting bracket (A) . Twist the canopy (B) clockwise
to lock . Then re-insert the mounting bracket screws (M)
and securely tighten all screws .
2 .
Insert blade (J) through slot in the side of the motor
assembly (C), ensuring the “THIS SIDE UP” label faces
the ceiling . Align the holes of one blade (J) with three
blade screw holes in underside of the motor assembly
(C) . Secure blade (J) with three blade screws (BB) and
blade washers (CC) .
Repeat for the remaining blades (J) .
Hardware Used
BB
Blade Screw
x 9
CC
Blade Washer
x 9
3 .
Remove one of the light pan screws (O) from the fitter
plate (D) . Then, insert the wires from the center of the
fitter plate (D) through the hole in the light pan (F). Align
the light pan (F) over the previously loosened light pan
screws (O), then place the keyholes of the light pan (F)
clockwise . Secure the light pan (F) with the previously
removed light pan screw (O) . Tighten all four light pan
screws (O) .
1
2
J
M
A
B
BB
CC
M
3
D
F
O
C
