8
INITIAL INSTALLATION
4. Loosen all four preassembled mounting bracket
screws (R), then completely remove the two
mounting bracket screws (R) from the round holes
of canopy (E). Set aside for later use.
Detach mounting bracket (D) from canopy (E).
5. Attach mounting bracket (D) to outlet box (not
included) using screws and washers provided with
the outlet box.
CAUTION:
It is very important to use the proper
hardware when installing the mounting bracket (D) as
this will support the fan.
Important:
If using the angle mount, ensure the open
end of the mounting bracket (D) is installed facing the
higher point of the ceiling.
6. Remove all 10 preassembled motor screws (Q) and
five preassembled plastic motor blocks from the
underside of the motor assembly (G). Discard the
motor blocks, but keep the motor screws (Q) for later.
For
Standard or Angle Mounting Instructions
, continue
to page 9. For
Closemount Instructions
, proceed to
page 11.
G
5
6
4
E
D
R
D
D
Q
Standard or
Closemount
Mounting
Angle
Mounting
Motor
Block
